DBX ZC-7 Page Assignment Controller for ZonePro

The DBX ZC-7 is a remarkable programmable push - to - talk page assignment controller designed specifically for ZonePro devices. It belongs to the Zone Controllers family, which greatly enhances the functionality of the DriveRack and ZonePRO product lines. These nine Zone Controllers utilize analog DC voltage to offer logic control, covering a wide range of operations such as zone source selection, volume adjustment, muting, program or scene selection, and fire safety muting. Wired with common and affordable CAT5 cable using widely - accepted RJ - 45 connectors, it can reach up to 1000 ft, providing simple yet elegant solutions for contractors. The ZC - 7 remote device allows computer - programmable push - button up/down volume control for dbx ZonePRO devices. It also features DIP switches, enabling easy identification when connected to the processing device via a CAT 5 cable on RJ - 45 connectors. All information is subject to change without notice. Recommended for installation projects. Key Features: Computer - programmable volume control for dbx ZonePRO devices, DIP switches for easy identification, and it's a reliable dbx ZC - 7 remote controller. Technical Specifications: Connectors: (2) RJ - 45. Series Wiring: Maximum cable length varies with the number of Zone Controllers (e.g., three Zone Controllers: 600 ft; six Zone Controllers: 300 ft). Parallel Wiring using ZC - BOB: Up to six Zone Controllers can reach 1000 ft. Parallel Wiring Cable: CAT5 or CAT5E with 28.6 Ohm/M (Ohm/1000ft.) nominal DCR and rated VW - 1 or higher. Safety Agency Certifications: UL 60065, IEC 60065, EN 55013, E60065.

Using the DBX ZC - 7 is quite straightforward. First, connect it to your ZonePro device using a CAT5 cable with RJ - 45 connectors. You can use either series or parallel wiring depending on your setup. For series wiring, note that the maximum cable length changes based on the number of Zone Controllers you have. When using parallel wiring with the ZC - BOB, you can connect up to six Zone Controllers and reach up to 1000 ft. Once connected, you can use the push - buttons on the ZC - 7 for volume control. The DIP switches on the device help in identifying it when connected to the processing unit. Keep in mind that all the product information might change without prior notice. For maintenance, keep the device in a clean and dry place. Avoid exposing it to extreme temperatures or moisture. Also, make sure the cables are properly connected to prevent any signal loss. Check the safety agency certifications regularly to ensure the device is in compliance with all safety standards.